Acova ASV-060-090/GF, Инструкция по эксплуатации

Страница: 29 / 45

If the remote control is too far away from the heating appliance, the latter will continue to
operate in
the last mode sent by the controller. Changes of mode relating to the operation
of a programme or manual boosts will however continue as normal.
The appliance will resume normal operations within a few seconds when the remote
control is within range again
(within 10 metres) .
55
05/2019
54
40019308
4.3 Status of LED (on radiator or towel dryer)
4.4 Remote control displays
STATUS
COLOUR
Fixed Flashing Off
Green Eco mode
•
Standby
•
Powered down
•
Stop (pilot wire)
•
Stop load
shedding (pilot
wire)
Red Comfort mode Boost
Blue
Frost-free mode /
Load shedding (pilot wire)
Open window
detected
Yellow T° override°
(+ colour sequence)
Error: contact after-
sales service
Pink
Pairing error /
Appliance not paired
Pairing underway
Setpoint
temperature
NOTE:
Screen lighting turns off automatically if no key has been pressed for the past
5 seconds .
The screen goes to standby after 1 minute .
The standby mode does not affect the functioning of the radiator, and pressing
any key will make the screen light up again.
The screen must be on for the pressing of a key to have an effect
(e.g. temperature setting, changing a parameter, etc.).
Operating Modes
Scroll through times of day (prog)
Days of the
week (prog)
Prog
Mode
A) Procedure using the receiver unit on your appliance:
Press
twice on the LED on your appliance (4 seconds max for
the 2 presses).
The LED is
flashing pink .
You then have one minute to pair your appliance with the remote
control.
B) Procedure using the remote control:
(if the remote control screen is off, turn it on by pressing a key)
mode
boost
mode
boost
mode
boost
mode
boost
mode
boost
mode
boost
Press for
5 seconds
on the +
key.
If pairing fails, the display on the
control goes back to
rF 0
. Start the pairing
procedure again by pressing the + key for 5 seconds .
Check beforehand that the receiver unit is still ready for
pairing: the LED should flash pink.
If the radiator is still not paired to the remote control
after three attempts, the remote control and
receiver need to be reset (see
chapter 5.3 parameter 9).
  
  
Pairing
complete.
The remote
control goes
to Frost-free
mode.
The clock
icon
will flash until
the date and time are set.
NOTE:
Operations A and B
can be done in any
order.
Appliance
search
takes
about
one
minute .
A remote control
which has already been
paired cannot be paired
again. If an attempt to do
so is made, the receiver
flashes white
3 times .
Synchronisation