ACOUSTIC SOLUTIONS SP150, Руководство пользователя

Страница: 15 / 17

After the SP150 has checked the hard drive, if there is any
malfunction it will display a malfunction code.
Please consult your local dealer or ring the Acoustic
Solutions customer helpline for further information.
08712 307747 inside United Kingdom
+441327 340601 outside United Kindom
Please note that our customer helpline is open
Mon-Fri 09:00-16:30 (GMT) excluding National holidays.
As software updates become available it is advisable to
install these.
Note: please ensure that you have registered your SP150
using the warranty card to ensure that you receive the
latest updates.
If it is necessary to update the operating software, this will
be introduced into the SP150 on a CD rom.
1. Press eject on the front panel (14), to open the CD
drawer.
2. Place the update CD into the drawer with the label
uppermost and press eject again.
3. The CD drawer will close load the CD, and it will
display that the CD is not an audio CD.
4. From the System menu select the “Upgrade” function
and press “OK” on the remote control (15).
5. The SP150 will then update the operating software
from the CD rom in the CD drawer.
6. The SP150 will then prompt you to reboot the system
for the new software to take effect. This will require the
power to be turned off, and then on again using the
power button on the front panel (8).
The SP150 uses the CDDB database to name CD’s
which are played or stored on the hard drive.
Note: please ensure that you have registered your SP150
using the warranty card to ensure that you receive the
latest updates. These are free for the first 12months.
It will be necessary to update the CDDB database to
ensure that the latest CD releases are recognised by the
SP150, and this will be introduced into the SP150 on a
CD rom.
1. Press eject on the front panel (14), to open the CD
drawer.
2. Place a CD into the drawer with the label uppermost
and press eject again.
3. The CD drawer will close load the CD, and it will
display that the CD is not an audio CD.
4. From the System menu select the “Update CDDB”
function and press “OK” on the remote control (15).
5. The SP150 will then update the database from the CD
1. The output signal level of the SP150 can be changed to
match the input sensitivity of the amplification equipment it
is connected to.
2. The default output level setting of the SP150 is 27, this
equates to 280mV.
3. To alter this setting use the up/down arrow keys on the
remote control to select a level between 0 and 31.
4. Press OK to confirm your selection, or after a time out
period of 30 seconds the SP150 will accept this new output
setting and revert back to the normal play menu.
5. The following table represents the respective output
senstivity levels for the output level numbers:
It is possible to check the revision number of the software
loaded onto the SP150.
From the System menu when scrolling through options
you will see a screen similar to this:
The SP150 will allow some self diagnostics on the hard
drive. This may be necessarry if the SP150 malfunctions
or develops a problem.
From the System menu scroll down using the up/down
keys on the remote control until you see the check disk
screen:
Press the OK button on the remote control to initiate a
check of the harddrive
Volume setting table:
Volume 0 2mV
Volume 3 4mV
Volume 7 8mV
Volume 11 17mV
Volume 15 35mV
Volume 19 70mV
Volume 23 140mV
Volume 27 280mV
Volume 31 560mV
OUTPUT LEVEL
SOFTWARE REVISION NUMBER
CHECK DISK
UPGRADE
UPDATE CDDB
page 15
���������
������������
��������������
�������������
ADV
ANCED FUNCTIONS
ADVANCED FUNCTIONS