2.3) Enter ON Mode
Before switching on, please pay attention to the follows:
Ø Avoid temperature and motion disturbances in front of the camera
such as big leaf, curtain, air-conditioner, air outlet of the chimney
and other heat sources to prevent f r o m false triggering.
Ø The height from ground for placing the camera should vary with the
object size appropriately. In general, one to two meters are preferred,
Slide the power switch to the ON position to power on the camera
and enter into the ON mode. Before entering into the ON mode, you
can adjust the camera the target monitoring area by laser pointer
Ø After switching on the camera, the motion indication LED (red) will
blink for 15s. The 15s is a buffering time before autonomic capturing
photos or videos,e.g. for closing and locking the bottom cover, fixing
the camera on a tree and walk away.
Ø In ON mode, it is unnecessary to use the remote control. The camera
will take pictures or videos automatically according to the default
settings or previous custom settings. The camera has the sound
recording function, so the sound will be embedded in the video clip
while capturing a video.
2.4) Enter TEST Mode
Slide the power switch to the TEST position and enter into the TEST mode.
In this mode you can take pictures or video clips like a regular digital camera,
or enter the Menu to set up parameters by remote control.
2.5) Enter OFF Mode
Slide the power switch to OFF position to power off the camera. Off mode
allow user to insert SD ,SIM Card, replace Battery etc. Please note that even
in the OFF mode, the camera still consumes certain power at µA level.
Therefore, please remove the battery if the camera will not be used for a
long time
(
Cautions: The Power Switch can’t be Slide From “OFF” Mode directly
to “ON” Mode or From “ON “ Mode to “ TEST” Mode.
Each time,
user should Slide power switch into “OFF” Mode, then into “Test” Mode
and Finally Enter into “ON” Mode
)