The remote control is an input device of the camera and is primarily used
for customer settings and password input. This is an infrared
type wireless remote controller.The maximum remote distance is 9
meters. There are fifteen buttons on the remote control.
Select Item(UP)/Increase value
Display Menus /Exit Make Selection/Enter
Change Value (Left) Change Value (Right)
Select Item(Down)/Decrease
A) Press the punctuation “
” to turn on laser
direction pointer in the night. Please note: the Laser
could be harmful to eyes if pointed at other humans.
CAUTION: If you are not using the camera for an extended period of
time, it is highly recommended that you remove the batteries from
the camera to avoid
possible acid leak that may damage the camera which would void the
warranty.
QUICK START
2.1) Load Batteries
To supply power for the camera, Eight AA size batteries are needed, Voltage
of each battery should be
1.5V.
Open the bottom cover by pulling down the lock hole. Confirm that the power
switch is at the OFF position, pull out the battery depot. Load the fully
charged batteries into the depot according the polarities sign shown
below. Push back the depot to the battery chamber. The following batteries
with
1.5V
output can be used:
（
NOTE: rechargeable battery voltage should
be also reach 1.5V each, 1.2V Rechargeable Battery will only working short