not show the MPNO’s name or signal?
An:
Take one of the batteries out from the battery box, and then replace it.
Reattach the box to the camera, tighten it, and switch to TEST mode. Wait for
about 45 –60 seconds, and then check the signal.
I just installed the upgrading firmware. Do I need to re-set up the camera
and the MMS function?
An:Y
es. After you upgrade the camera, all previous settings of the camera
and the MMS are gone. You need to run the
setup
.exe file on the enclosed CD
to set up the camera again.
4.7)Troubleshooting FAQ
AcornGuard AG-690MG series Camera won’t power on?
1. Make sure that you have installed at least 4 batteries in the battery
compartment all stacked together.
2. Make sure that the batteries are installed correctly.
3. When moving the switch from “Off” to “Test” or “On”, the user
should make sure that the switch stops in a positive position to ensure
the proper mode (and do not move the switch too fast).
A. The voltage should be between 4.5V and 6.5V;
B. In Test mode, camera will automatically power off if there is no
operation in 1 minute.
4.
Make sure batteries power is enough; or else, camera may power off
suddenly when IR leds is on in TEST mode.
AcornGuard AG-690MG series hunting camera stops sending photos to
email or mobiles.
1.
Check if the SIM card is out of charge.
2.
Check SIM card MMS function with mobile phone.
3.
Check if the signal is too weak or there is no signal.
4.
Make sure the GPRS setting is right (check the manual)
AcornGuard AG-690MG series hunting camera stops taking images or
won’t take images
1. Please make sure that the SD card is not full. If the card is full, the camera