15
Subject to technical alterations
ACO Haustechnik
0 1 7 3 . 0 2 . 5 9 G
2.5 Battery connection:
The battery is already connected. If a battery exchange is required, this
may only be carried out by an electrician. The battery has two connec-
tions which may not be mixed up!
2.6 Extension set:
If the supplied cables and hoses are too short (standard length
5 m), the cable extension set (10 m), art. no. 620438, can be
ordered. However, a total length of 15 m should not be excee-
ded as otherwise functionality can no longer be guaranteed.
Batt. Cable Terminal strip
(+) red battery (+)
(-) black battery (-)
The fault transmitter contact closes in case
of a fault signal. During configuration of the
contacts care has to be taken that a max.
current of 500 mA is not exceeded. In addi-
tion, only pure Ohm resistive loads may be
connected. Signalling devices, PCs, tele-
phones and alarm devices can be connected
to the contacts.
2.7 Switch-on process:
The ACO QUATRIX-K automatic anti-flood protection system must
be carried over in a definite condition by the control unit. This
is achieved by the switch-on process (insert mains connection).
An initialisation is always carried out (fig. 29)
when the control is switched on from a currentless condition
by double-pressing the system reset button.
Initialisation is done in such a way that the valve is completely
closed at first and then re-opened. When reaching the open posi-
tion, initialisation is finished and control passes into automatic
operation (green diode lights).
Fig. 29
Prior to wor-
king at the
control or at
the water connection,
isolate from mains elec-
trical supply!
2.9 Resetting the control
Isolate from mains electrical supply. By pressing the system
reset button and the control button at the same time for 5
seconds, the control appliance is reset to works settings, i. e.
is carried over in the currentless condition.
If both buttons are operated at the same time for 5 seconds, all
light-emitting diodes flash simultaneously before the appliance swit-
ches off.
