XP-5R Beam
-
37
-
3. Loosen the screws (C).
4. Unplug all the connect wires over the belt.
5. Change a new belt (D), put the belt around the
axis gear and motor gear.
6. Plug all the connect wires back upon the belt.
7. Tighten all the screws.
F. If The tilt belt is broken
1. Turn off the mains power.
2. Loosen all the screws (A) and open the right
arm cover (B).
3. Loosen the screws (C) that fix the bridge.
4. Change a new belt (E). Please adjust the
tension of the belt properly. Note: do not fix
the belt too tight as it is can easily rupture.
5. Reverse the procedures from step 3 to 2.
10. Maintenance and Cleaning
Maintenance:
Ballast
A. As the pictures shown above, please replace the cable or cable joints immediately once
they’ve turned yellow.
2-
1. Safety Instruction
WARNING
Please keep this User Guide for future consultation. If you sell the unit to another user, be
sure that they also receive this instruction manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty.
The dealer will not accept liability for any resulting defects or problems
.
y
Unpack and check carefully that there is no transportation damage before using the
unit.
y
The unit is for indoor use only. Use only in a dry location.
y
Do install and operate by qualified operator.
y
Do not allow children to operate the fixture.
y
Use safety chain when fixing the unit. Handle the unit by carrying its base instead of
head only.
y
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces.
y
Be sure that no ventilation slots are blocked; otherwise the unit will be overheated.
y
Before operating, ensure that the voltage and frequency of power supply matches the
power requirements of the unit.
y
It’s important to ground the yellow/green conductor to earth in order to avoid electric
shock.
y
Maximum ambient temperature TA: 40
. Don’t operate it
℃
when the temperature is
higher.
y
Don’t connect the device to any dimmer pack.
y
During initial start-up some smoke or smell may arise. This is a normal process and
does not necessarily mean that the device is defective, and it will decrease gradually
within 15 minutes.
y
Make sure there are no flammable materials close to the unit while operating to avoid
fire hazard.
y
Examine the power wires carefully; replace them immediately if there is any damage.
y
Unit’s surface temperature may reach up to 85
. Don’t touch the housing bare
℃
-handed
Please read carefully the instruction manual, which includes important
information about the installation, usage and maintenance.
www.bluelight.at
www.bluelight.at
