4. Assembling the wings
Required parts:
- Left and Right Wings
- Carbon tube
- wooden connector
- 4x Screws (4x2mm)
Mark the middle of the carbon tube. Slide the tube smoothly in the provided holes of the wings. If needed, fix the tube
with glue in one of the wings.
Connect the wings twisted (right picture). Make sure that the servo cables remain on the bottom of the wings.
Insert the wooden connector on the notch on the bottom of
the wings. Fix it with the 4 screws (4x2mm).
5. Servocables of the wings
Required parts:
- 2x Servo Y-Cable
Extend the servo cables on the wings with the Y-
Cables. Pay attention to the marks on the cables.
If you use a Computer-RC with at least 7 channels you
don’t need the two y-cables.
