-2-
HARDWARE INSTALLATION
1.
Plug the antennas in
Plug the 2 antennas of your choice (not included) into the N-type connectors.
For single antenna installation, use Ant.1 connector.
WARNING: It is recommended to connect a 50 ohms terminator on
unused antenna connector. If not, it may disturb radio link quality and
data throughput, and as well as waterproofness.
2.
Connect the power supply
See the “specifications” section about the characteristics of the power supply.
The device has 3 sources of power supply:
-
Power 1 through M12 PWR connector
-
Power 2 through M12 PWR connector
-
PoE through M12 LAN2 connector
The device has no ON/OFF switch. It turns-on automatically when power is
applied. Check LEDs Power1 and Power2:
-
Power1 LED is ON if Power1 power supply or PoE source is ON.
-
Power2 LED is ON if Power2 power supply is ON.
The Diag LED stays red for around 60 seconds, until the device is fully ready
to use. Then the Diag LED turns green.
3.
Connect the Ethernet cable
Plug the Ethernet cable to the device’s LAN1 or LAN2 M12 connector. Check
that the corresponding LAN1 or LAN2 LED turns ON at that point.
If the device is powered by a PoE source, use exclusively LAN2 connector.
SOFTWARE CONFIGURATION
4.
Modifying the default IP address 192.168.1.253
From any PC of the local network, run the ACKSYS windows application
named
WaveManager
(found on our website).
Select the device and click on «
setup
» button. You can configure the IP
address to make it compatible with your network or activate the DHCP client.
