Ackermann
Page: 23 // 28
SHAVER SYSTEM
Information relating to the
disposal of battery in the EU
Equipotential
(equalising potential)
Temperature range 10°C-40°C
Caution, glass fragile
Protect against moisture
This way up, do not turn over!
Code of the receiver and of
the console of wireless
footswitch
Caution, consult accompanying
documents
Source of non-ionizing radiation
9.2. PACkAGE lABEl
The package label contains information about the contents of the package, such as: product name, reference number,
quantity, date of manufacture, name and address of the manufacturer.
The unit label contains necessary information about: the type of equipment, manufacturer, date of manufacture, supply
voltages, power draw and type of fuses. It also identifies the unit by serial number and reference number.
The labels should under no circumstances be removed or damaged.
An illegible label makes it impossible to identify important parameters. A unit without a label or with a damaged label that
does not contain identification data for the product is not subject to the
9.3. DISPOSAl Of USED ElECTRONIC PRODUCTS
Prior to disposal, follow chapter 6 “Maintenance and care“
In the European Union:
The current EU-wide legislation, implemented in each member state, requires that all electrical and electronic Equipment
marked with this symbol is disposed separately of other waste. This includes electronic devices or electrical accessories
such as cables, electronics, etc. When disposing of such products, please follow the advice of your local authorities. The
symbol shown on electrical and electronic products only applies in current EU member states.
Outside the European Union:
When disposing of used electronic and electrical products outside the European Union, please contact
your local authorities to obtain information on the proper method of disposal.
10. INfORMATION ABOUT POTENTIAl ElECTROMAGNETIC INTERfERENCES
Table 11. Guidance and manufacturer’s declaration – electromagnetic emissions:
EMC – guidance and manufacturer’s declaration (EN 60601-1-2: 2007) Arthroscopy Shaver System 16-2050
The
Arthroscopy Shaver System
is intended for use in the electromagnetic environment specified below. The customer or the user of
the Arthroscopy Shaver System should assure that it is used in such environment.
Emissions test
Compliance
Electromagnetic environment - guidance
RF emissions CISPR 11
50/60 Hz
The Arthroscopy Shaver System uses RF energy only for its
internal function. Therefore, its RF emissions are very low and not
likely to cause any interference in nearby equipment.
40°C
10°C
