Stationary Photoionization Detector SPID2
User Manual
SPID2 - User Manual (en) - 1.11.docx
Analytical Control Instruments GmbH, Volmerstraße 9A, D-12489 BERLIN, Germany, www.aci-berlin.de
Version 1.11
Page 16 of 60
5.
User Interface
5.1.
Startup
After the power supply voltage has been applied, the device is automatically switched on and carries
out a warm up and self-diagnostic sequence, which takes approximately 30 seconds. During this
period, the current loop output is set to startup state (see chapter 0 ).
If the self-diagnostic sequence is satisfactorily completed, the main screen is displayed and the current
loop output moves to a value representing the measurement value.
5.2.
Display Overview
Alarm Indicator
Purge Indicator*
Unit
Measured value
Gas Name
Indicator
*available if AutoPurge is activated
5.3.
Operating Buttons
The device is operated using three magnetic field sensitive buttons, which are placed (left, middle,
right) at the bottom line under the display. An appropriate magnetic pen is supplied with the device.
How To
–
Activate a Button
1.
Place the magnetic pen directly above the display on the corresponding area.
2.
The display will response to user input and shows the navigation bar.
3.
Select the desired menu item.
After a period of 120 seconds of inactivity, the navigation bar disappears automatically.
