![background image](http://html.mh-extra.com/html/acer/angora-am10/angora-am10_service-manual_5836048.webp)
38
Chapter 2
Super IO Device
Onboard FDC Controller
If your system has a floppy disk controller (FDC) installed on the system board and you want to use it, you can
select Enabled. If you install an add-in FDC or the system has no floppy drive, select Disabled in this field.
Onboard Serial Port 1
This item allows users to manually set the address for serial port 1.
Onboard Serial Port 2
Use this item to enable or disable the onboard parallel port and to assign a port address.
UART Mode Select
Select an operating mode for the serial port. The default is [Normal].
UR2 Duplex Mode
This option is only available if an infrared port mode is selected in the UART Mode Select item. Select full or half
duplex mode. Full-duplex mode permits simultaneous two-direction transmission. Half-duplex mode permits
transmission in one direction only at a time.
KLIJ
:Move Enter: Select +/-/PU/PD :Value F10: Save and Exit ESC:Exit
F1: General Help F5: Previous Values F7: Optimized Defaults
Parallel Port Mode SPP
X ECP Mode Use DMA 3
X UR2 Duplex Mode Half
Onboard Parallel Port [378/IRQ7]
Onbaord Serial Port 2 [2F8/IRQ3]
Menu Level
X
UART Mode Select [Normal]
Phoenix - Award WorkstationBIOS CMOS Setup Utility
Super IO Device
Onboard FDC Controller [Enabled]
Help Item
Onbaord Serial Port 1 [3F8/IRQ4]
Содержание Angora AM10
