9.
2
8
.20
2
2
ACE123
15
Memory
Location: The Vision Series model can contain up to 2 DIMMs of memory. The memory modules
are found on the motherboard to the right of the heat sink fan, refer to Figure 1 for additional
guidance.
Type and number of fastenings: Two (2) latches per memory module.
Tools required: None.
Procedure
Step 1: Ensure the desktop is off, unplugged, and any potential energy is dissipated.
Step 2: Remove the top
panel from the chassis as indicated in the “Chassis Cover” section of this
manual.
Step 3: After locating the memory, press both release tabs on the ends of the memory module to
unlock the carriage. Use gentle, even force, on either side of the memory module to remove from
the memory slot.
Step 4: Repeat Step 3 for each piece of memory in the system.
Reinstallation
Step 1: Ensure the
desktop is off, unplugged,
and any potential energy
is dissipated.
Step 2: Remove the top
panel from the chassis as
indicated in the “Chassis
Cover” section of this
manual.
Step 3: Using the graphic,
to install new or additional memory DIMMs, open the latch, and gently push down, with equal
pressure distribution on both sides of the memory module. Ensure the memory is fully engaged,
then re-engage the latch to secure the memory in place.
Disposal:
Selective Treatment/Special Handling Per Annex VII, Directive 2012/19/EU: The memory
module is a printed circuit board of greater than 10 sq. cm and must be removed from the
device and must be disposed of, or recovered, in compliance with the requirements of Directive
2008/98/EC.
