9.
2
8
.20
2
2
ACE123
13
Reinstallation
Step 1: Ensure the desktop is off, unplugged, and any potential energy is dissipated.
Step 2: Remove the top
panel from the chassis as indicated in the “Chassis Cover” section of this
manual.
Step 3: Lift chassis carriage into the upright position.
Note: B
oth the 2.5” and 3.5” have the same basic steps for removal and reinstallation.
Step 4: Pull the blue carriage tray at the center, semi-circle shape, this will disengage the
interference clips on the main chassis carriage.
Step 5: Once the blue carriage tray is removed, the HDD can be slide into place, the holes on the
HDD should align with the holes in the blue carriage tray, the Phillips screw locations should be
accessible and can be placed.
Step 6: Attach data cable from HDD to motherboard, the recommended
header is “SATA6G_1”.
Step 7: Attach SATA power from power supply unit to HDD.
Disposal:
Selective Treatment/Special Handling Per Annex VII, Directive 2012/19/EU: The HDD
contains a printed circuit board of greater than 10 sq. cm and must be removed from the
device and must be disposed of, or recovered, in compliance with the requirements of Directive
2008/98/EC.
