MP5032-2104
XLR8 HEATED PLATEN
17
3.2 RTD SENSOR
1. Follow typical safety protocol for electrical and work
space and tools. Lock out tag out.
2. Disconnect from power source.
3. Lower handle assembly.
4. Remove the controller cover
5. Remove the inner controller cover
6. Disconnect RTD terminals from Control board and
snip any wire ties that are binding the RTD wires
together.
7. Loosely install controller cover assembly.
8. With one hand on the handle to prevent the arm
assembly from rapidly lifting up, remove the heater
cover 8-32 X 3/8” Truss head screws doing the ends
first then finish in the center of the heater cover.
9. Slowly raise the arm assembly to its max height,
leaving the lower half of the heater assembly laying
on the griddle surface.
10. Carefully move the insulation away from around the
offending RTD to gain clearance to the threaded end
of the RTD sensor.
11. Use a 3/8” wrench to back out the RTD.
12. Reverse procedure to reinstall.
13. Use permanent lock-tite on the #8-32 heater cover
screws when reinstalling.
