Manual Part # 800-1403-001 Revision 06-01-2020
Page 11 of 16
Programming Mode:
Many features of the readout can be customized, plus additional tools can be
configured using the programming menu. Consult the Complete User Guide at
for more information about accessing, changing, and
saving customized settings.
Before making changes, open the readout case and verify the programming
menu is accessible. The jumper to the left of the battery has three pins. Ensure
pins 1 and 2 are connected with a shunt before proceeding. (After making
changes, you can move the shunt to pins 2 and 3 to prevent further
programming changes.)
To start the programming menu, turn on the readout.
1. Press and hold the UNITS key.
2. Quickly press and release DATUM key. You will see
PG on,
then
Pr1
.
3. Release the UNITS key.
4. After a moment, the value for Pr1 will display.
•
Change the parameter value using the PLUS or MINUS keys.
•
Default the parameter value using the DATUM key.
•
Advance to next parameter by pressing the UNITS key.
•
Exit programming menu following steps 1-3 above (OR wait 30
seconds). Note: Changes made are immediately active.
Parameter
number
What it does
Default value
Pr1
Sets the value that is displayed when
DATUM key is pressed.
0.000
Pr2
0 = numbers increase when encoder
moves right
1 = numbers decrease when encoder
moves right
0
Pr3
0 = PLUS, MINUS, and DATUM keys
are operative
1 = These keys are locked out.
0
Pr4
Value controls the resolution for
decimals.
3
Pr5
How much motion is needed to wake
up the readout.
0.004 inches
Pr6
Controls if fractions round up or down.
0 (round down)
Pr7
Controls resolution of 4
th
decimal place
(in inches)
1 (
.0005”
resolution)
Pr11
Controls which units modes appear.
0 (All units)
Pr12
Auto-off timer (in minutes)
15
