Accurate Technology ProPanel-HD, Общее руководство по эксплуатации

Страница: 20 / 24

ProPanel-HD (FW4), Revised August 2020 Page 20 of 24
Common Errors
The following is a list of the most common error codes and their meaning.
For additional help with any error message, consult factory.
Message What it means
no Enc There is not an encoder connected to the readout, or the
connected encoder has a fault.
no Pos The readout has not been calibrated yet.
b fail The battery in the readout needs to be replaced
immediately.
f fail The readout cannot display fractional values larger than
399 63/64 inches.
P fail The battery in the readout needs to be replaced
immediately. Check programming values after new battery
is installed.
LOCK The keypad is LOCKed, but an attempt was made to
change the calibration. Unlock keypad to fix, see page 14.
P LOCK The keypad is LOCKed, but an attempt was made to
change the calibration. Change programming parameter
Pr3 to fix. (See
www.proscale.com/700-1600-246 for more
details.)
no oFF Offsets are disabled, but an attempt was made to apply an
offset value.
MON flashing Monitor mode is turned on, and the system is out of the
allowable position.
no Co Non-linear compensation is enabled, but there is no look-
up data for the displayed measurement.
uL, LL Limits mode is turned on, and a limit has been exceeded.
Reset
The digital readout’s parameters have just been defaulted.
Bad pt The readout expected an entry different than it received.