ACCURAT GUARD 1000, Инструкция по эксплуатации, Страница: 32 / 56

32
Turn off the UPS in Battery mode
Press and hold the ON/OFF button for 3 seconds to turn off the UPS. The UPS output
supply is cut off, and the UPS will turn off after approximately 30 seconds.
6.4.3. Entering the Settings Mode
Pressing the ON/OFF button will put the UPS in Settings Mode. When the UPS is in
Standby or Bypass Mode,
press the SET/ENTER button for 5 seconds , and the UPS
will enter the Settings Mode. Here you can adjust the settings of output voltage, and
frequency, enable/disable bypass, or ECO mode, and turn the EPO function on or off.
Use the Up page and Down page buttons to change the settings and short press
the SET/ENTER button to confirm the change. Then turn off the mains power supply,
wait for the UPS to power off, and then turn on the UPS again to activate the settings
change.
6.4.4. Battery Self-test
In Normal Mode, press the Up Page Button until you hear the beep. The UPS will
switch to the battery test mode and check the battery status. If the battery is
abnormal, the UPS will exit the battery test mode and the alarm will sound with the
battery icon flashing. If the test mode ends up normal, the UPS will automatically
switch to normal mode.
6.4.5. Alarm Mute
When the UPS is in Battery Mode, the alarm sounds once every 7 seconds. You can
disable the alarm tone manually by pressing the Down Page button until you hear the
beep. Press the Down Page button for 4 seconds to enable the alarm again. The Alarm
Muting feature is available only in battery mode and doesn’t apply to any other UPS
alarm.