www.accuenergy.com
69
V: 1.0 Revised: Sept. 2019
Chapter 10: Web Interface Readings and Parameter Settings
DNP Enable: Select 'Enable' to enable the function and to further configure the settings relat-
ed to the DNP function.
TCP/IP Mode: By default the TCP/IP is set as TCP&UDP, it can be changed to TCP dual endpoint
mode or UDP only.
Local TCP Port: Enter the port number for the local TCP server.
Local UDP Port: Enter the port number for the local UDP server.
Destination IP address: The default IP address is set as *.*.*.* to allow all incoming requests.
Dual endpoint IP port: Enter the port number for the endpoint IP server.
Destination UDP port for initial unsolicited null responses: Enter the port number of the
destination UDP server for the initial unsolicited null responses.
Destination UDP port for response: Enter the port number of the destination UDP server for
response.
Link address: Enter the address number of the slave device.
Master link address: Enter the address number of the master device.
Source address validation: By default the validation is disabled, select 'Enable' to enable the
destination address validation.
Supports Unsolicited Reporting: Select 'Enable' to enable the function and further configure
the settings related to the unsolicited report.
Number of Unsolicited Retries: Number of retries can be selected as '0', '10' and 'infinite'.
Unsolicited response trigger Condition(Num of class # events): Enter the number of events
for each class to setup the trigger point. The unsolicited response will be triggered once the
number the class events reaches the configured triggering number. The range is from 0-255.
Unsolicited response trigger Condition(Hold time after class # events): Enter the threshold
holding time for each class, the unsolicited response will be triggered once the event holding
time is longer or equal to the threshold time. The range is from 0-86400000 milliseconds.
Support for broadcast functionality: In DNP there three broadcasting addresses that are sup-
ported. Enabling this setting would allow the module to respond to requests (from the client)
sending them to the broadcasting addresses.
