MOUNTING
HOLES
FIGURE 16
15. Remove the two bolts holding the front of the EVAP cannister with 16mm socket/wrench. (Figure 17)
FIGURE 17
16. Install the upper bracket holding the seamless tank to the frame underneath the vehicle. The tank bracket will slide
in between the cross member and the EVAP cannister using the hardware removed in Step 15. The tank will face
forward toward the engine bay, while the compressor and VU4 valve block will face the rear of the vehicle. (Use Blue
Loctite when installing the M8 fasteners to the factory cross member.) (Figure 18)
FIGURE 18
With the brackets lined up, reinsert the 16mm bolts and tighten. Ensure clearance of muffler to bracket. (Figure 19)
FIGURE 19
23
24
AA-4397 Installation Manual
REV 01 | 05/25/2023
WIRING
