Accu-Sort AXIOM 400, Руководство по эксплуатации продукта

Страница: 40 / 132

3-16
Mechanical Installation
AXIOM™ 400 Product Manual
Accu-Sort Systems, inc. 03-AXIOM400-Mechanical_Installation_R10.doc
Mounting the I/O Modules
The wiring base supports four (4) optional input or output modules that can be
used for optional trigger inputs or to operate diverters, alarms, etc. The
optional I/O modules are not installed at the factory.
Figure 3-16: I/O Module Location in Wiring Base
To install your optional I/O module(s):
1.
Lift the insulating cover (shown in figure above) out of the way to gain
access to the wiring base printed circuit board.
2. The I/O modules may be plugged into locations I/O 1 through I/O 4. These
locations run right-to-left, as shown on the insulating cover label.
3. Plug the appropriate I/O module directly into the wiring base printed
circuit board.
(See Figure 3-17, left photo.)
4. Using a screwdriver, secure the I/O module by tightening the captive screw
(that goes through the module) into the circuit board. DO NOT over-
tighten screw.
(See Figure 3-17, right photo.)
Figure 3-17
: Installing an I/O Module
I/O MODULE APPLICATIONS
OUTPUT MODULES
ƒ
Activate diverter/sorter for no
read, multi-read, match, or no
match conditions.
ƒ Activate device (e.g., beacon light)
to indicate any of the above
conditions.
ƒ
Activate device for use as a “life
condition’ indicator.
ƒ
Activate device to follow the
trigger condition.
ƒ
Activate alarm.
INPUT MODULES
ƒ Additional photoeye input for
Start/End Trigger
NOTE: The following input module
applications require custom
software.
ƒ
Transmit photoeye
ƒ Divert Accomplished photoeye
ƒ
Reboot signal