Accora Configura Advance SC3, Инструкция по эксплуатации

Страница: 7 / 20

7
7.
There is a cover attached to the bottom of the
backrest to cover the backrest hinge. To fit this
cover, place the first part of the cover (Fig 5, Item
1) over the rear part of the hinge protection plate
(Fig 5, Item 2), then pull the front part of the cover
(Fig 5, Item 3) down over the hinge.
8.
Figure 6 shows the backrest hinge cover from the
inside. Place the lower pocket of the backrest
hinge cover (Fig 6, Item 1) over the lower part of
the hinge protection plate (Fig 5, Item 4) to secure
the hinge cover in place.
9.
Repeat steps 7 and 8 to secure the cover on the
other side.
10.
Secure the backrest cushions to the backrest with
the Velcro flaps. Each cushion is attached to the
backrest with the Velcro flap at the top of the
cushion. The top cushion has a double width
Velcro flap and is marked Pillow
– Top. The middle
and bottom cushions are identical.
11.
Ensure the female poppers on the overlay are
engaged on the male poppers on the frame, 3 EA
on left- and right-hand side. (Fig 7, Item 1)
12.
To fit the sidepieces, pull out the plunger located
under the seat on one side of the chair (Fig 8, Item
1) and rotate it through 90 degrees to lock it open.
Fig 9 shows the plunger locked open.
13.
Undo the hand screw (Fig 8, Item 2).
Figure 7
Figure 4
2 1
Figure 5 – (Seat cushion shown removed for clarity.)
2
1
3
4
1
Figure 6
Figure 8
2
1
1