User’s Manual
8
4.2 Setup With Answer
Display page (I)
If you select the “Setup With Answer” function mode, then press the multi-selector, the LCD-display
will show you as below:
If there is no LED unit connected to this XB-R1 setup controller, LCD will show you like this:
If there is any LED unit connected effectively to this XB-R1 controller, after the Scanning, LCD will show
you like this:
Display page (II)
Note:
Unit Group
is from 1 to 100,
Unit Number
is from 1 to 999,
Address Set
is from 1 to 512,
the
Work Modes
varies with the different LED units (RGB, C&B, COLOR, …, AUTO, MANUAL,
etc.) The AUTO and MANUAL modes are for
Master
control, and the other modes are for
Slave
control.
Glide Effect
function
can be set as “Yes”(enabled) or “No”(disabled).
①
This mode is not available for the one-way output device.
②
Each LED unit owns the only one ID used to select. And Unit group is used to set a group
LED Unit, Unit number to one of a group unit. Commonly, the unit group of LEDs controlled by
one way DMX is the same. And Unit Number can be set according to user’s needs in Setup No
Answer Mode.
The content of this ID item
is unchangeable.
<
ID:
XXXXXXXXXXX…
>
Unit Group:
XXX
>
Unit Number:
XXX
>
↓
Work Mode: RGB
>
Glide Effect:
XXX
>
Address Set:
XXX
>
Confirm to send
>
Selective Copy >
Copy to all
>
Scanning LED Unit
Please Wait…
<
Scan Complete.
No LED Unit In Line
Please Check!
<
Setup No Answer
>
Setup With Answer
>
DMX Controller
>
LCD Backlight:xxxx
>
