User’s Manual
6
(3) MANUAL Work Mode:
If you set the Work Mode as “MANUAL”, the LCD-display will immediately show you as below:
You can rotate the multi-selector clockwise or counterclockwise to select relevant item, then use the
multi-selector to adjust or confirm your setting.
In the
MANUAL Work Mode
, relevant parameters are as below:
Blue/Duration:
0%-100%
Red /Speed:
0%-100%
Green/Dimmer:
0%-100%
Select the “Confirm” item and press the multi-selector, LCD will show you the above display.
(When adjusting relevant parameters, the being-controlled LEDs will respond sensitively.
The LEDs will briefly flash for several seconds during data sending.)
*
User can call up
Semiautomatic Setup No Answer
function by rotating the multi-selector and
selecting the “Selective Copy”, then press the multi-selector, the LCD will show you as below:
Unit Group
:1~100;
Unit Number
:1~999;
Total Channel
:1~48.
①
It is necessary to set the first LED properly in Setup No Answer Menu before entering.
②
DMX Addresses of LEDs depend on work modes.
③
DMX Addresses are channel total of LEDs after confirmation. And Unit Number would increase
<
Unit Number:
XXX
>
Work Mode:MANUAL
>
Blue/Duration:
XXX
%
>
↓
Red /Speed:
XXX
%
>
Green/Dimmer:
XXX
%
>
Confirm to send
>
Selective Copy
>
Copy to all
>
↑
Blue
/Duration:
XXX
%
>
Red /Speed:
XXX
%
>
Green/Dimmer:
XXX
%
>
Confirm to send
>
Unit Number Mode
LED Unit Setup
Data Sending
！
Please Wait…
<
Unit Number:
XXX
>
Work Mode: RGB
>
Glide Effect: XXX
>
↓
Address Set:
XXX
>
Confirm to send
>
Selective Copy
>
Copy to all
>
< Unit Group: XXX >
Unit Number:XXX >
Total Channel:XXX >
Addr: XXX Confirm >
