Acclaim Lighting Linear One DMX Exterior, Руководство пользователя

Страница: 20 / 28

18
www.acclaimlighting.com
ADDRESSING FIXTURES
TO ADDRESS FIXTURES USING THE ACCLAIM LIGHTING XMT-350
1 Connect the XMT-350 to the DMX input line of either a single fixture or multiple fixtures in
a pre-arranged daisy chain configuration.
2 Power on the fixture(s) and the XMT-350.
3 On the XMT-350, press the
MODE button, then use the arrow buttons to highlight the
RDM function and press the button to select. The XMT-350 will search for RDM devices
and after a short while the XMT-350 will display a list of all located fixtures:
ACTUAL ADDRESS:
PATCH TO ADDRESS:
OK CANCEL
001
001
LINEAR ONE DMX EXTERIO. (001)
MAIN
LINEAR ONE DMX EXTERIOR
LINEAR ONE DMX EXTERIOR
LINEAR ONE DMX EXTERIOR 005
009
012
PATCH OPTIONS 004/004
RESTART PATCHING
MAIN
LINEAR ONE DMX EXTERIOR
LINEAR ONE DMX EXTERIOR
LINEAR ONE DMX EXTERIOR 005
009
012
PATCH OPTIONS 004/004
LINEAR ONE DMX EXTERIO... 001
The fixture that is highlighted within the list should begin flashing its emitters to identify
itself.
4 On the XMT-350, press the right arrow button to change to the PATCH tab:
5 If necessary, use the up/down buttons to choose an alternative fixture.
6 Press the button to set the address for the currently highlighted fixture:
7 Use the up/down buttons to set the required DMX address and then press the button
to store it within the fixture.
8 The highlight will automatically move to the next fixture so that you can address it.
Repeat steps 5 to 7 until all fixtures are addressed.
Note: DMX addresses shown in brackets, e.g.
(001), have been temporarily assigned by the
XMT-350, but are not yet stored within the
fixture(s).
DMX CHANNELS
The number of DMX channels required per fixture depends on the model and, for 4’ models,
also the mode (see page 19):
•
Dynamic white models 2 DMX channels (8 channels for 4’ models in EXD. mode)
•
RGBW/A models 4 DMX channels (16 channels for 4’ models in EXD. mode)