Acclaim Lighting Linear One DMX Exterior, Руководство пользователя

Страница: 21 / 28

19
www.acclaimlighting.com
SETTING THE CELL MODE (4’ MODELS ONLY)
The 4’ (1.2m) models offer a choice of modes that determine whether all of the emitters act
as a single 4’ cell or as four separate 1’ cells, each with their own set of DMX addresses:
SINGLE CELL (STD MODE)
INPUT ALL CELLS COMBINED
CELL 1 INPUT CELL 2 CELL 3 CELL 4
SEPARATE CELLS (EXD MODE)
The cell mode is configured in the same Personality section that deals with signal loss
behavior (as discussed on the next page).
TO SET THE CELL MODE USING THE XMT-350
Note: If you are setting a
Fast Color On
mode, first use your XMT-350 in Send mode to apply a desired
color/intensity mix to the fixture before switching to RDM mode (see page 20).
1 Connect the XMT-350 to the DMX input line of the Linear One installation.
2 On the XMT-350, press the
MODE button, then use the arrow buttons to highlight the
RDM function and press the button to select. The XMT-350 will search for RDM devices
and after a short while the XMT-350 will display a list of all located fixtures. The fixture
highlighted in the list should show output from its emitters to identify itself.
3 If necessary, use the up/down buttons to highlight an alternative fixture.
4 Press the button to view details for the chosen fixture and then use the down button
to highlight the DMX PERSONALITY entry:
LINEAR ONE DMX EXTERIOR
MODEL:LINEAR ONE DMX EXTERI...
MAN:
DMX START ADDRESS:
DMX SLOTS:
ACCLAIM LIGHTING
001
4
LABEL: LINEAR ONE DMX EXTERI...
DMX PERSONALITY:STD.BLACKOU...
LINEAR ONE DMX EXTERIO...
002: STD.FASTCOLORON
001: STD.BLACKOUT
003: STD.LASTRECEIVED
005: EXD.FASTCOLORON
004: EXD.BLACKOUT
006: EXD.LASTRECEIVED
016 CH
5 Press the button to view the options:
6 Highlight the required signal loss behavior mode: Blackout, Fast Color On or Last Received
(as discussed on the next page) with either the STD. or EXD. prefixes to choose either the
single cell or separate cell modes, respectively.
7 Press the button to fix the highlighted choice.
8 Press the button to return to the previous screen.
4’ RGBW/A models require 4 DMX addresses in
STD mode, rising to 16 DMX addresses in EXD.
4’ DW models require 2 DMX addresses in STD
mode, rising to 8 DMX addresses in EXD.