HBLED HSLED HNLED INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: [email protected]
®
WALL MOUNTING
Mount to a weatherproof
Junction Box (not supplied)
and
Cover Plate (not supplied)
as shown. Apply weatherproof
silicone sealant around the edge of the Junction Box. This is
especially important with an uneven wall surface.
1.
Thread fixture into
Cover Plate
. Use silicone sealant or
teflon tape around the thread of the arm.
2.
Connect wires as shown in the wiring section.
3.
Attach
Cover Plate
to
Junction Box
.
4.
Aim fixture in the desired direction and tighten locknut
and
Arm Screw
.
Cover Plate
(not supplied)
GROUND MOUNTING
Mount to a
Mighty Post
(RAB Cat# MP19) as shown.
1.
Thread fixture into
Mighty Post Cap (supplied upon
request)
. Use silicone sealant or teflon tape around the
thread of the arm.
2.
Connect wires as shown in the wiring section. Push all
wires inside the
Mighty Post (supplied upon request)
.
3.
Place
Mighty Post Cap
on the
Mighty Post
.
4.
Aim fixture in the desired direction and tighten locknut
and
Arm Screw
.
Junction Box
(not supplied)
Mighty Post Cap
(supplied upon request)
Mighty Post
(supplied upon request)
Arm Screw
Arm Screw
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
.
Fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required
for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON
FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.
CAUTION: For proper weatherproof seal, apply weatherproof silicone sealant around the edge of the Junction Box. This is
especially important with an uneven wall surface. Use silicone sealant or teflon tape around the thread of the arm.
