Acclaim Lighting Flex One Exterior HO, Руководство пользователя

Страница: 10 / 30

8
www.acclaimlighting.com
TO FIT THE LENS
1 Measure the exact length of lens required between the end
caps at each end of the channel.
2 Carefully cut the lens to length. Ensure that any resulting
burrs are removed.
3 Along each side of the channel (where the
lens will sit) carefully run a thin bead
of sealant (Dow Corning® 799, 1199
or equivalent). The bead should be
large enough in diameter to ensure
a good seal between the channel and
the lens, but not so much that excess
sealant runs into the channel and
contaminates the lens inner face.
4 Determine the correct orientation
of the lens - it has a wider outer
face and a slightly narrower inner
face.
TO RECESS IN GROUND
1 Fit the Flex One tape to the channel (see page 7).
2 At the end where the connection will take place, fit an
End
cap with hole .
3 Feed the cables through the end cap and
carefully solder to the contact pads, if
necessary (see page 5).
4 At the other end of the channel, fit
a standard
End cap
.
5 To ensure long term protection
against water ingress, coat all
internal end cap seams with a
bead of sealant (Dow Corning®
799, 1199 or equivalent). Pay
particular attention to the cable
entry point.
6 Fit and seal the required lens (see below).
7 Place the sealed tape/channel assembly into the prepared ground recess.
+24
V
+24
V
+24
V
+24
V
+24
V
5 Carefully lower the lens onto the beads of sealant and ensure that it fully seats in place.
Wipe away any excess sealant.
6 Apply further sealant between the lens and the end caps.
UV stabilized,
walk-over rated
lens.
Note: Ensure sufficient
strain relief where the
cables enter the channel.