Acclaim Lighting Flex One Exterior HO, Руководство пользователя

Страница: 7 / 30

5
www.acclaimlighting.com
CUTTING AND SEALING THE TAPE
Flex One tapes are supplied with a one metre feed cable at one end (with bare tails).
TO CUT THE TAPE
Flex One tapes are marked with a cut line every one
inch (25mm) - every six LED emitters.
IMPORTANT: Do not cut the tape at any
location other than the cut line. Ensure the
cut is made cleanly thru the silicone outer and
along the line.
+24
V
+24
V
+24
V
24V
Cut line
TO SEAL A CUT TAPE
Once a Flex One tape has been cut, apply
a little silicone sealant (Dow Corning® 799,
1199 or equivalent) to the cut end and fit one
of the supplied end caps to ensure a fully
watertight seal.
+24V
+24
V
+24V
End cap
+24
V
+24
V
+24
V
+24
V
+24
V
For the most reliable results, you are
recommended to use a new spool, with
molded feed cable intact, to start each
fresh run and to always fit an end cap to
the far end (as discussed above).
However, when using channels, the feed/
end caps are slightly too large to fit within
the channel extrusions and would need to
be located outside.
Where this is not appropriate, the feed
contacts will need to be soldered within
the channel. If you use this method,
ensure sufficient silicone sealant is applied
to the joint to provide reliable water
resistance.
Feed/end cap placed outside
of the channel extrusion