AccessECU 2005, Руководство пользователя

Страница: 8 / 70

SETUP
Initializing your AccessPORT Initializing your AccessPORT Initializing your AccessPORT Initializing your AccessPORT Initializing your AccessPORT
To begin using your AccessPORT, you must first perform the following steps that
will enable your factory ECU with the proprietary AccessECU technology. You
cannot access the Main Menu or other features of the AccessPORT until it has
been installed on your ECU using the following steps.
The AccessPORT comes pre-loaded with Maps. In the event you wish to change
the Maps prior to installing your AccessPORT, please refer to page 47 before
performing these steps.
Step 1: Step 1:
Step 1: Step 1:
Step 1:
Put your key in the ignition and leave it in the ‘OFF’ position. Connect the two
green Test Mode connectors located under the driver’s side dash, left of the Steering
Column. To connect the Test Mode connectors, you simply need to plug them
into each other. Please refer to the diagram below:
W W
W W WARNING
ARNING
ARNING ARNING ARNING:
Before beginning, please verify your vehicle is in proper working order
and is properly maintained. It is also imperative that the battery be
fully charged and in good condition. If the battery voltage drops
below an acceptable amount during the reprogramming process,
the ECU will be damaged and cannot be recovered. Your vehicle will
not run if this occurs. Avoid all electrical noise that may interfere
with the sensitive communication between the AccessPORT and the
ECU. Any interference may result in a programming failure and
damage to your ECU.
Steering
Column
Driver’s Side
Door
TTTTTest Mode Connectors (A) est Mode Connectors (A)
est Mode Connectors (A) est Mode Connectors (A) est Mode Connectors (A)
8
(NOTE NOTE
NOTE NOTE
NOTE: In the event your Test Mode connectors are already connected, refer to
page 47 for additional steps before continuing)