7.
Tighten in a crisscross pattern to 5.5kg-m (40 ft-lb).
8.
Remove the jack.
BULB REPLACEMENT
The wattage rating of the bulb is shown in the below. When replacing a
burned bulb, always use the same wattage rating.
Headlight -----12v/35w
Brakelight -----12v/21w
Headlight
Brakelight
To replace the brakelight bulb, use the following procedure.
1.
Remove the two screws and remove the lens cover.
2.
Push the bulb in and turn it counterclockwise to remove.
3.
Install the new bulb by turning it clockwise while pushing in.
4.
Install the lens cover.
Caution: Tighten the lens cover screws only until they are snug.
FUSE
The main (7.5 Amp) fuse is located on the frame near the battery under
the seat.
Note: To remove the fuse, compress the locking tabs on either side of the
fuse case and lift out.
If there is any type of electrical system failure, always check the fuse
first.
Caution: Always replace a blown fuse with a fuse of the same type and
rating. If the new fuse blows after a short period of use, consult an
authorized dealer immediately.
STORAGE COMPARTMENT/TOOLS
A basic tool kit is provided with the
ATV. It is located under the seat.
