ABX Pentra 80 RAB108EA, Руководство пользователя

Страница: 219 / 306

Maintenance & Troubleshooting
.Replacement procedures
Pentra 80 - User Manual - RAB108EA
7–5
▼ Sampling probe
Sampling probe must be decontaminated as follows:
1- Prepare a solution of Sodium Hypochlorite to 100ml/l*.
2- Fill a 5ml tube with this solution.
3- Run 5 analysis on bleach, using the «Stat» mode as described in (See Section 2,
3.3. Stat mode , page 2-11).
Please also refer to the W.H.O (World Health Organization) guidelines: «Laboratory
Biosafety Manual, 2nd edition», for further information
2.
.
Replacement procedures
This section describes how to replace:
◆ a low level reagent (see 2.1. Reagent replacement, page 7-5)
◆ an optical bench lamp (see 2.2. Optical bench lamp replacement, page 7-11)
◆ the sampling probe (see 2.3. Sampling probe replacement, page 7-13)
2.1. Reagent replacement
2.1.1. Reagent locations and connections
When installing the Diluent on the system, it is most important to maintain the depth
of the container no lower than 80 cm (31.5 in.) below the instrument. If the depth
limit is exceeded, erroneous results will occur.
Diluent and Waste tubing lengths are critical upon installation. Follow the recom-
mended lengths for best results:
DILUENT input tubing: Cristal 3x6/ 2 meters (80 in.) maximum.
WASTE output tubing: Cristal 4x6/ 2 meters (80 in.) maximum.
Bottles and container locations (see Fig. 7–1, page 7-6):
1- ABX Lyse
2- ABX Basolyse II
3- ABX Eosinofix
4- ABX Cleaner
5- ABX Diluent
6- Waste container