11
9. Following successful activation
When the alarm centre is successfully activated (also with automatically omitted zones), an acknowledgement is received after the delay time has expired. This
acknowledgement can have different forms:
•
Acknowledgement tone on the wireless alarm system
•
Acknowledgement tone on the info module
•
An SMS from the wireless alarm system
•
Acknowledgement display on the external wireless siren
•
Activation of a switch output on the accessory module
9.1. Acknowledgement
tone on system
The wireless alarm system is
activated after the delay time
has expired. Activation is
acknowledged on the system
by an acoustic signal.
9.2. Acknowledgement
tone on info module
After the delay time has
expired and the system has
been successfully activated,
the info module acknowledges
activation with an acoustic
signal. At the same time, it
shows an active state via the
red LED.
9.3. SMS message
The alarm centre sends an
SMS after the delay time has
expired. This message shows
who activated the system and
when. In certain
circumstances, transmission
of the SMS can be slightly
delayed.
9.4. Acknowledgement
on siren
The alarm system sends a
message to the external siren
after the delay time has
expired. This activates the
strobe for about 5 seconds.
This flashes 3 to 5 times in
acknowledgement.
9.5. Accessory module
All types of acknowledgement
displays can be triggered
using the accessory module.
These include LEDs, exterior
lights or additional buzzers.
The output can be triggered
continuously (for the entire
activation period) or in pulses.
After acknowledgement is received, the system is activated and intrusion into a monitored area results in an alarm. Activated areas are marked with an “S” on the
display.
The wireless alarm system must be deactivated before entering the monitored area again. Deactivation can be carried out in several different ways.
Beep beep
Beep beep
FLASH
FLASH
FLASH
