24
Using the system
The following is displayed:
Press required
Remote button
2. Press and hold a button on the device you wish to test until the transmit LED on the device flashes.
The keypad gives a double-beep confirmation tone and you will see the results of the test:
RM001.S:User 001
Set Ptns> SS:9
The top line shows the number of the device, the button you pressed, and the name of the user
the device is allocated to. The bottom line shows the function of the button and the strength of the
signal.
If the signal strength is less than 4, contact your installer.
3. Repeat step 2 for the other buttons.
Note:
If you wish to test the Hold-Up Alarm buttons, make sure you press them both at the same
time.
4. Press
4
to end the test.
4.12.6 Testing user HUAs
Master and admin users can use Test – User HUAs to test radio Hold-Up Alarm (HUA) devices.
To carry out the test:
1. Select Test – User HUAs.
The following is displayed:
Press both HUA
buttons
2. Press and hold both HUA buttons on the device you wish to test until the transmit LED on the device
flashes. If the device has a lock button, make sure you unlock the button before the test. The keypad
gives a double-beep confirmation tone and you will see the results of the test:
User: User002
SS:9
The top line shows the name of the user the device is allocated to. The bottom line shows the
strength of the signal.
If the signal strength is less than 4, contact your installer.
3. Repeat step 2 for the other HUA devices.
4. Press
4
to end the test.
