22
Using the system
4.
Press any other key to test it. The display should confirm the key you pressed.
5.
Press
✘
to finish the test.
4.12.3 Performing a Walk-Test
Master and admin users can use Test – Walk Test to test detectors without starting an alarm. Walking past
motion detectors should be enough to trigger them. If you have detectors connected to doors or windows,
you will have to open them to trigger those detectors.
During the test, if the detector is working, the control unit sounds a confirmation tone and indicates that
the detector has passed the test.
Note:
You cannot test wired HUA buttons, fire detectors, and 24-hour zones during a walk test. The
control unit will always start an alarm if you activate those detectors.
To carry out the test:
1.
Select Test – Walk Test. The following is displayed:
WALK TEST
Chime Once
2.
Press
◀
or
▶
to select one of the following:
Once Causes a single chime for each zone that is triggered during the walk test.
Off Switches off chiming.
On Generates a chime every time a zone is triggered.
3.
Press
▲
or
▼
followed by
✓
to select the method of testing:
System
This option allows you to walk round the entire system and test all the zones.
Partitions
This option allows you to select one or more partitions, and test only the zones within those
partitions.
Press
▲
or
▼
to scroll up or down the list of partitions, and
▶
to display “Yes” at the end of the
bottom line to mark the partition as one you want to test.
Zones This option lets you select one or more individual zones, and test only those zones.
Press
▲
or
▼
to scroll up and down the list of zones. Press
▶
to display “Yes” at the end of the bottom
line to mark the zone as one you want to test.
4.
Press
✓
to begin the test.
The top line shows how many detectors remain to be tested. The bottom line provides a list of all the
detectors ready for testing (press
▲
or
▼
to scroll through the zones):
10 Zone(s) to test
Zone 040
