Using the system
11
A Hold Up Alarm (HUA) is started when both of these keys are pressed (if enabled by the
installer).
* This is the default action; the installer can configure these keys perform a different setting action, or to
operate an output.
Note:
A Keypad can be programmed to belong to specific partitions. When the Master user enters
his code on a Keypad, it inherits all the partitions on the system. Thus, setting faults, will be shown
from all partitions. Partition type users/code can be used to keep the Keypad indications just on the
dedicated Keypad partitions.
4.2 About the standby screen
When the system is idle (either while set or unset), the display shows the “standby screen”. For example:
S e c o r i s A l a r m P a n e l
1 0 : 4 3 0 3 / 1 2 / 2 0 1 9
4.3 Setting the system
Readying the system to start an alarm if someone moves into a protected area is called “setting” the
system.
You can set your system using a variety of different methods, depending on system configuration. The
following explains a typical method using a keypad.
1.
Enter your access code at the keypad. If you enter your access code, the display shows a * for each
completed digit:
E n t e r A c c e s s C o d e :
( * )
2.
If setting options are displayed, you can press
s
or
t
followed by
4
to choose the option you
require:
S e t t i n g O p t i o n s
F u l l S e t A l l
•
Full Set/Fulll Set All
: To set the whole system. Alternatively, press the A key*.
•
Partitions
: To set or part set a partition. Alternatively, press the B, C or D key to full set a partition*.
* Your installer may have configured the system to allow you to quick set using A, B, C or D without
entering an access code.
3.
You will hear a continuous exit tone (unless the system is configured for silent or instant setting).
The system sets when one of the following occurs, depending on how the system is configured:
•
Immediately
•
After a period of time
•
When you exit the premises
The A, B, C or D key illuminates to indicate the set status (unless disabled by the installer). For example, by
default the A key is illuminated if partition 1 is fully set.
