– 40 –
Se
tti
ng
U
P
SETTING UP AND ESTABLISHING THE
NETWORK
Setting Up
Notes on networking the radio-inter-
linked smoke alarm (abbreviated here
to RISA or “alarm”):
The alarm should only be activated as
described in this manual:
Activation and setup of radio groups:
The alarms must ONLY be set up
• singly
• one after another
• in direct proximity to their intended
installation position (in the room in
which each unit will be used).
Do not network alarms that are less
than 1 m apart – signal overlap –
faults in network setup
> 0
.50
< 1
.00
> 20°
> 20°
> 1.00
1/2
1/2
> 20°
< 1.00
> 0
.50
< 1
.00
- Platforms/galleries <16 m
2
and at least 2 m long and
wide: 1 detector
• over 16 m
2
: install additional detectors
- Roof slopes (slopes below 20° are considered flat
ceilings):
In the event of a fire, this device quickly detects the
build-up of smoke and also the associated rise in
temperature in the room. In order to warn you in good
time, it then emits a loud alarm sound. If you decide
that there is no real need to escape the building you
can temporarily deactivate this signal (for approx.
10 minutes), or temporarily disable it before sounding,
by gently pressing the Test/Stop button (Fig. 1, IV). We
recommend that you then provide good ventilation to
the room to prevent the alarm being triggered again.
Содержание RWM450
Страница 32: ... 32 ...
