Absco Industries
Assembly Instruction Manual
ABSCO POOL PUMP COVER
MODEL: PPCK-PTX
5’ W x 5’ D x 4’ 10” H
Model: PPCK-PTX
1.0
7
27/4/23
1.
Layout and overlap two
PPB
sheets by one rib as shown.
You’ll need to turn one 180
degrees.
Align them so the two rib holes
overlap and the edge holes are
to the outsides.
2.
Fasten with 3/8” self tapping
screws through prepunched
sheet-to-sheet holes on overlap.
If you can’t see bottom hole twist
the sheet left or right.
Make a new hole with supplied
drill bit if bottom hole is too far
up or down the sheet or not
found.
3.
Attach the top and bottom
channels using the SNAP-TiTE
method.
Make sure you have the short
side of the channel to the
outside of the sheeting
REAR PANEL ASSEMBLY
81F
81F
edge holes to outside
edge holes to outside
- This completes the rear panel -
1 required
FAST001
PPB
PPB
