Absco Industries
Assembly Instruction Manual
ABSCO GABLE CARPORT
MODEL: GCPDN2
6.0mW x 6.0mD x 2.98mH
Model: GCPDN2
8/06/23
15
1.
Take a pair of
086
sheets and
overlap by 1 rib.
2.
Check the ends are flush and
then make marks along the outer
edges as per the dimensions
shown.
3.
Using a straight edge &
marker or chalk line mark the
angled line and carefully cut
using tin snips.
TIP: This cut edge will be
covered by barge flashing.
4.
You’ll have four pieces.
That’s the sheets done for the
right side of a gable end.
Repeat the last steps, with the
angle going the other way, to
make the four left sheets.
5.
Repeat steps until you have
enough pieces to sheet the front
and rear of the carport. 16 sheets
total.
Fitting sheets to framing.
Start with the centre-most sheets
and align the straight edge with
the bottom of the truss.
Every second pan fasten using a
hex head tek screw. Make sure
to
not
use the neoprene washers
here.
Avoid screw placement too close
to existing truss screws. These
can distort the sheeting.
GABLE SHEETS
600
80
340
340
086
086
