Absco Industries
Assembly Instruction Manual
ABSCO GABLE CARPORT
MODEL: GCPDN2
6.0mW x 6.0mD x 2.98mH
Model: GCPDN2
8/06/23
12
1. Centre Truss
Secure centre truss to edge
beams.
Measure in 2960 mm from one
end of the edge beam to mark
the centreline of the truss.
Secure three
MPB
to each side
as shown with 6 screws. Truss
must sit 80 mm up from the
underside of the edge beam.
Repeat for other beam then
safely lift truss into position and
secure with hex head tek screws.
NOTE: You will have to remove
wafer head tek screws where
they interfere with the
MPB
s.
2. Post Angle Braces
• Use two
ZACO232
angle
braces to sandwich post
and truss. Fasten with 6 tek
screws per end. Make sure to
use wafer head tek screws to
outside of truss where sheet
will cover later.
• Position ZACO122 inside face
of edge beam to outside face
of post. Fasten with 3 hex
head tek screws per end.
NOTE: Ensure all posts are
vertical and make sure all braces
are fastened at 45 degrees.
3. Purlins
Place all six purlins on ‘uphill’
side of brackets and secure
with 4 hex head tek screws per
bracket.
ZACO232
ZACO122
Edge beam
End truss
80
CL
Edge beam
FRAME ASSEMBLY
End truss
Purlin
Purlin bracket
Refer to the engineering
drawings for further detail
such as screw fixing details.
