This document is the property of AS POOL - NextPool group and cannot be reproduced or communicated without our authorisation.
6
Installation instructions for an automatic safety cover - 6/14
2.1.2 Fig. 12
Option for fixing to the pool edge, fix the bracket
support into the concrete belt, under the coping,
applying the bracket against the pool side.
Fig. 12
2.1.3 Carry out a clipping and unclipping test on all
mechanisms.
Tighten the straps to press (flatten) the slats against
the wall and provide good pool safety.
All of the anti-lifting devices must be unlocked to
handle the cover and adjust the run stops.
2.2 Fixing with the Coverlock system
Make sure to position the harpoons and triggers in
relation to one another to obtain perfect alignment
and correct operation.
2.2.1 Fig. 13
Position each harpoon before ① on the male part
of the last cover slat using the two TFPZ 3 x 16 mm
screws.
Once all the required harpoons have been installed,
cut the remaining male part of the slat using a cutter
and a hack saw. This will protect the liner from any
damage.
Fig. 13
2.2.2 Fig 14: Fixing the triggers in the wall
Mark the holes by placing part ② in the centre of
the harpoon. Drill to a diameter of 6 mm and depth
of 35 mm.
Fix part ② using the TRHC M 5 x 30 mm screws and
M5 brass plugs. Make sure that this is horizontally
level.
Fix the face on part ② using the TRPZ 4 x 16 mm
screws.
Fig. 14
