11/22 - Installation instructions for the OPEN SURF System and OPEN SURF System 2 above-water automatic slatted safety cover
11
Fig. 25
-
Mark all the holes using a marker and drill Ø 8 mm
holes except for the centre hole which is Ø 10 mm.
Fig. 25
Ø 10 mm
Ø 8 mm
Fig. 26
-
Fix the plate using the M6 anchors and the
TRHC M6 x 35 screws.
Fig. 26
3.7 Removing the covers: (Surf 1 and 2)
Fig. 27
3.7.1
Removing Surf 1 covers:
Using an Allen wrench, unscrew the TRHC M6 x 16
screw, lift then remove the cover from the stand.
Fig. 27
Fig. 28
3.7.2
Removing Surf 2 covers:
Using an Allen wrench, unscrew the 4 lateral
TRHC M6 x 16 screws to release the cover. Tilt it
carefully backward then lower it.
Be careful, there are two pins below the aluminium
frame to position the cover on it. The cover must
be removed from these studs before removing it
carefully from the stand and placing it on the side.
Take care not to damage the wires connecting the
key switch to the motor during this dismantling.
Fig. 28
1
2
3
