EN
13
The belt is
running to
the left
1. Press and hold both Mode button and speed Increase button
on the Remote Control for over 3 seconds. Front panel will
display “CALI” and the speed is 4km/h.
2. Turn the left adjusting screw half a cicle clockwise using the
Allen key. Start the WalkSlim WalkPad 630 to check the new
position of the belt.
3. If the belt is still not in the middle repeat the action until
adjusted to a central middle position.
4. After adjusting the belt to the middle, start the WalkSlim
WalkPad 630, set to the maximum speed and observe
the tread belt to ensure that is running smoothly. If it’s not
centralised, then repeat the adjustment steps again.
The belt is
running to
the right
1. Press and hold both Mode button and speed Increase button
on the Remote Control for over 3 seconds. Front panel will
display “CALI” and the speed is 4km/h.
2. Turn the right adjusting screw a half circle clockwise using the
Allen key. Start the WalkSlim WalkPad 630 to check the new
position of the belt.
3. If the belt is still not in the middle repeat the action until
adjusted to a central middle position.
4. After adjusting the belt to the middle, start the WalkSlim
WalkPad 630, set to the maximum speed and observe
the tread belt to ensure that is running smoothly. If it’s not
centralised, then repeat the adjustment steps again.
The belt is
skidding
Turn the left and right screw half a turn clockwise at the same
time and then repeat the adjustment until running normally. Do
not tighten the screw excessively.
Tread belt
adjustment screws
