AbodeFit WalkSlim 410, Руководство пользователя

Страница: 12 / 16

Troubleshooting
The treadmill is
not working
• Make sure the power cord is properly secured into the power
outlet and that the switch is turned to the ‘ON’ position.
• Check the Safety Key is inserted in the correct position.
• If it is still not working, the fuse may have blown. Please
replace fuse according to the following instructions
1. Remove power cord from treadmill.
2. Remove the safety socket with a flat head screw driver.
3. Remove the fuse and insert replacement.
Note: the fuse tube specifications are 250V/10A Ø5x20mm.
• If the fuse is replaced and the treadmill still does not work ,
please contact our Customer Service Centre.
The tread belt is
not working
• Insufficient lubrication. Add silicone oil lubricant.
• Tread belt is too tight. This will reduce motor performance
and increase wear of rollers and tread belt. Adjust tread belt
tightness to the correct tension by using the allen key on both
sides of the treadmill and turning 180 degrees at a time. The
tread belt should be able to be lifted from the base by about
5-7.5cm by hand
The tread belt is
slipping
• Tread belt is too loose or too tight. Adjust the tread belt
tightness.
• While all treadmills have been precisely adjusted prior to
delivery, the running belt may need additional adjustment
after delivery and installation. Adjustment may also be
required throughout the life of the treadmill. Examples of when
adjustment is required because the belt is too loose: after
pressing the Stop button and as the tread belt begins to slow
down, it begins to slip instead of uniformly slowing. Adjust the
tightness of the belt by using the allen key on both sides of the
treadmills by turning 180 degrees at a time. Do not overtighten
the belt as it will increase the load on the motor and may cause
damage to the motor, tread belt and roller.
EN
12