
Installation –
Installing the eMH3 Wallbox on the POLEMH6 |
21
4
Insert a suitable supply cable with a length of about
1.8 m through the large grommet in the lower area
of the rear shell into the housing.
5
Insert the individual conductors into the termi-
nals of the RCCB and tighten them using the Phil-
lips-head screwdriver (torque: 2.5 to 3 Nm).
y
End ferrules must be fitted on flexible
conductors.
y
Operate the spring-loaded mechanism of the
PE terminal and attach the protective earth
conductor.
y
Use the connection pattern for TN systems on
page 24 to allocate the wires.
1,5 m
NOTE
Detailed information in the installation instructions
The installation instructions for the eMH3 Wallbox contain further detailed information on preparing for the elec-
trical connection.
6
Run the supply cable pre-installed in the wallbox
through the large cable inlet and into the housing of
the mounting pole.
7
Screw the wallbox into the mounting plate using
the Torx screwdriver and the screws supplied with
the wallbox.