ABL eMC2, Руководство пользователя, Страница: 20 / 44

INSTALLINg ThE ChARgINg pOLE
16
Installing the charging pole
After laying the foundation, mechanical as well as electrical installation of your eMC2
charging pole can be carried out and it can then be taken into operation. In principle,
installation should be carried out by qualified personnel. Inspection before taking the
charging pole into operation must always be carried out by a qualified electrical con-
tractor.
Your
eMC2 charging pole is an electrical device and is therefore subject to particular
prerequisites for indoor and outdoor installation: Although the housing of the eMC2
complies with the standards for the IP44 degree of protection, you must take into ac-
count certain environmental conditions, especially outdoors.
• For the safe operation of your charging pole, minimum distances to other technical
installations must be observed: You can obtain further information from your elec-
trical contractor or your distributor.
• The charging pole must be installed where it is freely accessible to all authorized
users.
• Choose an installation site that allows you to reach the charging socket of your
vehicle comfortably with the charging cable separately available for the eMC2 :
The cable must not under any circumstances be strained when connected to the
vehicle.
Delivery and transport
The eMC2 is preassembled at the factory and is delivered to the customer in mechani-
cally and electrically faultless condition. During transport, the eMC2 is protected from
damage by special packaging. Should the charging pole show visible damage or mal-
functions when it is unpacked at the installation site, please contact the responsible
transport company to clarify any questions of liability.
PLEASE NOTE:
ABL
guarantees the proper operation of the product after delivery and
installation within the applicable legal guarantee provisions. This guar-
antee is limited to damage that can be shown to have resulted from
normal use and obvious material or manufacturing defects.
Always make sure to keep the original packaging! In case of damage that cannot be
resolved on site, the eMC2 must be demounted and sent to the manufacturer for re-
pair. The following conditions must be met for appropriate return transport:
• For transport, the
eMC2 charging station must be protected from mechanical dam-
age by the original or other packaging.