28
Tip!
Control 18 can record codes from most IR transmitters on the market with a few
exceptions. You may have problems with a few or all of the functions for a certain IR
transmitter. In these cases it is possible to try another recording method. Instead, do as
follows in step 2; Press
P
and
1
at the same time but keep them pressed for
approximately 2 seconds until the indication lamp for the
Level
-button flashes green and
goes out. Control 18 is now in another recording mode. Otherwise use the same recording
procedure as above.
Adding a 4096-code
Control 18 is delivered with a special coded channel (4096) on the
Code
-button
!
. The
code is selected randomly. This coded channel is normally used for functions that require
strict authorization such as apartment or house doors. The code has 4096 different
combinations and has always the same code irrespective of which level you use. If you
have to program a new coded channel there are three methods of doing so.
Method one:
record the code from another transmitter, as described under
Recording IR
channels from another Transmitter
. By this method it's possible to program a coded channel
on any button independently of
level.
Method two:
Enter a numerical value between 0 and 4095. The indicated code will always
be associated with the
Code
-button
!
. It is then possible to move the code from this button
to other buttons (See under
Copying a button
). Then you can create a new coded channel if
you wish. Do as follows:
1. Press
P
and
!
at the same time. The indicator lamp on the
Code
-button and the
current level are now lit.
2. Enter a number from 0 to 4095.
3. Finish with
---
.
4. The indication lamp for the
Level
-button flashes green to show that the operation is
complete. Make a note of the chosen code for future usage.
Adding a 4096 code, method 2
Press
P
+
!
,
press the desired code
,
press
---
.
Default setting: Random code
