Abicor Binzel MIG ROBO, Руководство по эксплуатации

Страница: 33 / 80

BAL.0046 • 2019-02-07 EN - 15
MIG/MAG ROBO welding torch 9 Maintenance and cleaning
3 Lay out the cable assembly in a stretched position.
4 Push the liner through the wire conduit until the retaining nipple (4) .
5 Hand-tighten the nut (3) .
6 Cut off any excess length (x) flush with the torch head and pull out the liner again.
7 For a seamless transition to the contact tip, grind the start of the liner to an angle of approx.
40°. Deburr the cutting edge.
8 Push the tapered liner through the wire conduit to the retaining nipple (4) .
9 Screw on the nut (3) and tighten it with the switch key wrench.
10 Re-attach the equipment parts to the torch head (1) .
9.3 PA liner
1 Use the ABICOR BINZEL sharpener (1) to sharpen the start of the PA liner to approx. 40°.
2 Guide the PA liner (3) through the wire conduit until it reaches the contact tip.
3 Slide the retaining nipple (2) , O-ring and nut (4) onto the PA liner (3) , hold the PA liner taut
and tighten the nut (4) .
4 Guide the central connector together with the lengthy PA liner (3) through the central socket
into the wire feed unit.
NOTICE
• New and unused spiral liners or PA liners must be shortened to the actual length of the
cable assembly.
• The PA liner is attached in a similar way to the spiral liner. For more information, see the
wire feeder manufacturer’s operating instructions.
• PA liners are used for aluminum. PA liners and attachment materials are available on
request.
1 ABICOR BINZEL sharpener
2 Retaining nipple
3 PA liner
4 Nut
5 ABICOR BINZEL cutter
Fig. 4 Shortening the PA liner
1 2 3 4
5