Abicor Binzel MIG ROBO, Руководство по эксплуатации

Страница: 27 / 80

BAL.0046 • 2019-02-07 EN - 9
MIG/MAG ROBO welding torch 6 Putting into operation
6 Putting into operation
6.1 Equipping and connecting the cable assembly
Select the wire type and suitable wire guide for your application.
1 Lay the cable assembly out straight then push the cut-to-length wire guide (liner or PA liner)
through the torch neck from the central connector.
2 Tighten the nut using the switch key wrench.
3 Cut off the liner flush with the torch neck.
4 Make sure that the cutting edge is free of burrs.
6.2 Equipping the torch neck
For ROBO 241D and 455D, start by screwing in the replaceable tip.
1 Screw the spatter protector into the torch neck.
2 Screw the contact tip into the tip adaptor and tighten using a switch key wrench.
3 Slide the gas nozzle onto the torch neck, rotating it slightly clockwise.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance,
servicing, mounting, dismounting and repair work:
• Schalten Sie die Stromquelle aus.
• Sperren Sie die Gaszufuhr ab.
• Close off the coolant supply.
• Sperren Sie die Druckluftzufuhr ab.
• Trennen Sie alle elektrischen Verbindungen.
DANGER
Risk of injury and device damage when handled by unauthorized persons
Improper repair work and modifications to the product may lead to serious injuries and
damage to the device. The product warranty will be rendered invalid if work is carried out on
the product by unauthorized persons.
• Only qualified personnel are permitted to perform work on the device or system.
NOTICE
• Please take note of the following instructions:

3 Product description on page EN-5