EN - 20
BAL.0737.0 • 2019-11-15
8 Decommissioning
iROB Feed HA
4
Define the limits by pressing and turning <Main controller>
.
5
Repeat steps 3 and 4 until all desired limits are set.
Once a set safety limit is exceeded, a visible signal appears on the control panel. If a warning limit is exceeded, a visible
signal appears on the control panel. Furthermore, the welding procedure is immediately blocked.
7.5.1 The alarm menu
The alarm menu allows you to access a displayed alarm so you can receive important solutions for any problem that arises.
For a list of alarm codes
13.5 Alarm codes on page EN-32
8 Decommissioning
1
Switch off the power for
iROB Feed HA
with the main switch for the power source.
See the information in the operating instructions for the power source.
NOTICE
• You can set the start and end filter for welding. This helps prevent error messages while igniting or extinguishing the arc.
1
Alarm symbol
2
Alarm code
3
Alarm type
Fig. 13
Alarm menu
1
3
2
NOTICE
• When decommissioning the system, ensure that the procedures for switching off the welding components are observed.
Содержание iROB Feed HA
